HELLBOY BUST

This file is part of my Patreon welcome pack. To get this file at 100% off, support my Patreon. https://www.patreon.com/CloviSilva.

The 3D model is prepared and ready for 3D printing. Printing test performed on Creality LD-006 printer. Contents : Winrar file to unzip.

In addition to the STL file, the chitubox file with supports is also included, the same one I used to do the test print. You can use it as a reference to place your brackets if you prefer.

Tip for a good impression:

- Make sure your printer is calibrated

- Use the correct timing for your resin/printer

- After printing, wash the piece and remove the supports by hand or with the aid of pliers, remove carefully

- Cure your parts

- Finish your piece with sandpaper

- Paint your piece and make your collection. Thank you very much.